LZK | News Center

Have you encountered the same problem in the use of high-speed laser cutting machine tools?

It is normal for a high-speed laser cutting machine to be used for a long time, and it is normal for a small problem to occur. During the use process, the laser cutting machine will malfunction due to improper operation or other reasons. Although the failure is very small, it is precisely because of this small failure. It causes delays and even losses to production, so how to save these failures in time and reduce losses is what we are trying to understand.

1. When the power button is activated, the high-speed laser cutting machine does not work

1). Check whether the laser cutting machine is powered on, if it is not powered on, please plug it in first;
2). Whether the main board parameters of the laser cutting machine are correct, if not, please refer to the software instructions to correct the parameters;

2. The laser cutting machine is working without laser

1). Check whether the optical path of the laser cutting machine is offset, refer to the optical path for adjustment;
2), there is a problem with the circuit, at this time, you can insert the point ray with the laser cutting machine into the signal terminal of the power supply to judge;

3. Laser intermittently during work

1). Check whether the water circulation of the laser cutting machine is unobstructed, if not, please clean the water tank and pump, and unblock the water pipe;
2), check whether the power supply voltage is stable at this time, if the voltage of the laser cutting machine is unstable, please add a voltage stabilizer to the power supply;

4, the engraving is misplaced

1). For electrostatic interference problems, reconnect the ground wire and the ground is less than two meters;
2). The mechanical part is loose. Check if the gear top wire and belt are loose.

5, boot reset hit limit

Limit switch and signal problems, check the software parameter setting and limit switch;

6. The control panel does not light up

The line is loose, check the connection line from the motherboard to the panel is loose;

7, the processing size does not match the software setting size

1), install the software, you can install the original software of the machine to restore the original parameters;
2), through calculation, adjust each movement, through software calculation, re-enter the set size and the actual size of the processing in the software;

8. The laser cutting machine cannot process online data

1). Check whether the communication data line of the laser cutting machine is well connected, if not connected, please turn off and reconnect the data line;
2). Whether the software USB is successfully installed, if it shows that the installation failed, please reinstall the software and USB driver.

1592371121-_MG_4943